Cabrio Comfort Module for VW EOS Convertible

Order quantity exceeds stock quantity


Cabrio Comfort Module for VW EOS Convertible

249,00 EUR

incl. 19 % VAT

shipping costsadd. 

Shipping estimated:
Fri, 28. October.

On order and receipt of payment within
2 hour(s), 35 minute(s)

in stock | still 2 pc.

Last check: 2016-10-28 10:25:14
Model No: 33934
  • Roof module for enhanced roof operation for your convertible top
  • Roof operations will be controlled through the original remote control and / or the indoor roof switch
  • Software can be updated in the future
  • Module can easily be configured by the car's MFA - following options are available: No access through the menu in case of DIS with white illumination! - module will be delivered with standard settings
    • Module activation / deactivation
    • One-touch roof operation (remote / indoor roof switch)
    • Roof operation up to 45 km/h (configurable in 5 km/h steps)
    • Window position can be configured - only for roof opening - (options are: windows open / windows close)
    • Flash hazard can be activated during roof operation (only for remote operations)
    • Indoor roof switch reversing
    • Seamless roof operation:
      • roof operation will continue if you open / close the roof with the remote key and turn the ignition on/off
      • roof operation will continue if you open / close the roof with the indoor key and pull out the key

Characteristics of Comfort Module:

  • Due to safety concerns all operations can be interrupted
  • Roof operation will resume in case of over speeding, i.e: if you start a roof operation and drive faster than the specified max speed the roof operation will automatically resume by driving less than the max speed within 10 seconds.


  • Power Supply: 12 Volt (8–15 Volt)
  • Power Input: 90 mA
  • Standby Current: < 0.03 mA
  • Dimensions in mm: 54 x 45 x 22
  • Approval: E13 10R-02-3950

Scope of delivery:

  • Comfort Module
  • Cables


  • In the standby mode, each device consumes a small amount of power. Even complex vehicle controllers should not need more than 2.0mA to avoid an empty battery after a long standing time, e.g. after a holiday. Due to quality engineering and manufacturing, this module requires less than 0.03 mA.<
  • This device does not include any crush detection; therefore this module should only be used exercising caution and responsibility.
  • KUFATEC and the administrators of this website can NOT be held liable for any damage or injury caused by installing or using this product.